Saf OPAL Pro DeviceNet Manuel d'utilisateur

Opal Pro to DeviceNet Page 1 Opal Pro MS6 SERIES DeviceNet Interface Users Manual Revision 1.01

Opal Pro to DeviceNet Page 10 Output Words (Polled) Name Description Word 1 Status Bit 0 – Ready to Run (drive is enable and has 3 phase power) Bit

Opal Pro to DeviceNet Page 11 Word 12 Stack Size Opal Pro Stack Size in Amps Word 13 Comm Module Type 0 – None 2 – DeviceNet Word 14 Firmware Version

Opal Pro to DeviceNet Page 2

Opal Pro to DeviceNet Page 3 FOR YOUR SAFETY Only qualified personnel should install this equipment, after first reading and understanding all

Opal Pro to DeviceNet Page 4

Opal Pro to DeviceNet Page 5 Table of Contents INTRODUCTION ...

Opal Pro to DeviceNet Page 6 Opal Pro to DeviceNet Introduction The Opal Pro can be monitored and controlled over a DeviceNet communication network.

Opal Pro to DeviceNet Page 7 LED Indicators Two bi-colour (red/green) LED indicators are mounted beside the network connector. The upper LED (the on

Opal Pro to DeviceNet Page 8 Opal Pro Parameter Settings The parameters in the Opal Pro used to configure the DeviceNet interface card (group 14) are

Opal Pro to DeviceNet Page 9 I/O Configuration The Opal Pro does not currently implement the official DeviceNet Softstart device profile. The Opal